Jack Plate Plug-and-Play

Plug-and-Play jackplate. stereo/mono jack plate for back of cabinets. Outside dimensions: 110 x 102mm. Hole-to-hole dimensions (center-to-center): 95 x 83mm.

The Plug and Play eliminates the confusing switch found on most stereo cabinets. Just pick your impedance and plug in. Label is set at the common 4 / 16 Ohm Mono and 8 Ohm Stereo. Ready to install with a steel dish, wires, and speaker connectors. Direct replacement for many existing small jack dishes. Can be used for the following configurations:

4 ohm mono

8 ohm left + 8 ohm right stereo

8 ohm left only mono

8 ohm right only mono

16 ohm mono

The Plug and Play can be used with two 8 ohm speakers, four 4 ohm speakers, or four 16 ohm speakers.

Interior Length: 3.0 in.

Interior Width: 3.44 in.

Item Length: 4.03 in.

Item Width: 4.35 in.

Lead Length: 18 in.

Mounting Hole Center to Center A: 3.72 in.

Mounting Hole Center to Center B: 3.25 in.

Specs and Wiring diagrams:
[Download PDF Wiring Diagram here]
[Download PDF Dimensions here]
[Download PDF Speaker Z Wiring Examples here]